Service Enquiry

Pollution Control Norms

Pollution Control Norms

 

THE WATER (PREVENTION AND CONTROL OF POLLUTION) ACT, 1974

The Water (Prevention and Control of Pollution) Act, 1974 was enacted to provide for the prevention and control of water pollution and the maintaining or restoring of wholesomeness of water. According to this Act, No person shall, without the previous consent of the State Board.

 (a) Establish or take any steps to establish any industry, operation or process, or any treatment and disposal system or an extension or addition thereto, which is likely to discharge sewage or trade effluent into a stream or well or sewer or on land (such discharge being hereafter in this section referred to as discharge of sewage)

 (b) Bring into use any new or altered outlets for the discharge of sewage; or (c) begin to make any new discharge of sewage

 SERVICES OFFERED:

  • Complete design, installation commissioning, of Waste Water Treatment units such as Effluent Treatment Plants (ETP), Sewage Treatment Plants (STP), Oil and Grease Trap based on latest technologies. Up gradation/ modification/ Repair of Existing ETP/ STP. 
  •  
  • Preparation of technical Feasibility Report/ Adequacy report of Effluent Treatment Plants, Sewage Treatment Plants and performance monitoring. 
  •  
  • Effluent Analysis/ Testing of various Parameters of Water and Waste water such as BOD, COD, pH, TSS, TDS, Total Metal etc  from MoEF (Ministry of Environment and Forest) Recognized Lab.
  •  
  • Training on Environmental compliances such as operation and maintenance of Effluent Treatment Plants (ETP), Sewage Treatment Plants (STP). Maintenance of Log Book (Record) of ETP, STP.

 

Contact us and start your WATER POLLUTION COMPLIANCE Process Now

 

THE AIR (PREVENTION AND CONTROL OF POLLUTION) ACT, 1981

THE AIR (PREVENTION AND CONTROL OF POLLUTION) ACT, 1981 was enacted  to provide for the prevention, control and abatement of air pollution. According to this Act, no person shall, without the previous consent of the State Board, establish or operate any industrial plant in an air pollution control area.

Every person to whom consent has been granted by the State Board, shall comply with the following conditions, namely.

(i) the control equipment of such specifications as the State Board may approve in this behalf shall be installed and operated in the premises where the industry is carried on or proposed to be carried on.

(ii) the existing control equipment, if any, shall be altered or replaced in accordance with the directions of the State Board.

(iii) the control equipment shall be kept at all times in good running condition.

(iv) chimney, wherever necessary, of such specifications as the State Board may approve in this behalf shall be erected or re-erected in such premises.

 

SERVICES OFFERED:

  • Complete design, installation commissioning of Air Pollution Control Devices such as Cyclone separators, Wet Scrubber, Fabric Filters, Anti- Smog Gun etc Up gradation/ modification/ Repair of Existing units.
  • Preparation of technical Feasibility Report/ Adequacy report of Cyclone separators, Wet Scrubber, Fabric Filters and performance monitoring.
  • Air Emission Monitoring and Ambient Air Monitoring of Parameters of such as PM, PM2.5, PM10, NOx, SOx, HC etc from MoEF (Ministry of Environment and Forest) Recognized Lab.

 

Contact us and start your AIR POLLUTION COMPLIANCE Process Now

Related Products